Here's another entry from Dick Johnson's Encyclopedia of Coin and Medal Terminology.
-Editor
Strike Up, Struck Up.
To bring the surface relief of a numismatic or medallic item to its full intended height by striking in a press with proper dies and proper pressure βor the proper number of impressions (if a multiple-struck item). The pressman is responsible for every piece to be struck during his shift or production run and that they will be fully struck up with all detail intact.. He will frequently examine sample struck pieces (inspection) making sure the relief is as intended.
Press setup and running. To begin a press run of a new coin or medal the pressman or pressroom foreman will SETUP the press, and strike a first specimen or two. This is a trial strike and is purposely at a lower impression than anticipated not to break a die during this stage (thus trial strikes are purposely weakly struck). He will increase the pressure until he feels it will be the proper amount to fully strike up the piece. These are the first strike specimens he will examine very closely.
The pressman looks for the following: (1) every die cavity is filled, (2) all high points are intact, (3) there has been no die draw β metal flowing into then out of a die cavity β and (4) the dies are not misaligned. During the press run his sample inspections will always check the high points maintaining the relief is fully struck up. In addition he will check that no part of the die has broken, there are no hairline breaks, that the rims are intact and the dies have not rotated. He will use a magnifying glass for this inspection.
Multiple striking. Medals that are multiple struck will always exhibit the state not struck up until the final blow. This is very evident in a process set. Only the final blow will have every cavity filled and high points intact (multiple blows are required to move the surface metal to fill every die cavity). Ideally the freshly struck finished piece, either coin or medal, should match the relief of the artist's original three-dimensional model, the galvano pattern or dieshell, though in miniature size.
To read the complete entry on the Newman Numismatic Portal, see:
Strike Up, Struck Up
(https://nnp.wustl.edu/library/dictionarydetail/516836)
Wayne Homren, Editor
The Numismatic Bibliomania Society is a non-profit organization
promoting numismatic literature. See our web site at coinbooks.org.
To submit items for publication in The E-Sylum, write to the Editor
at this address: whomren@gmail.com
To subscribe go to: Subscribe
Copyright © 1998 - 2025 The Numismatic Bibliomania Society (NBS)
All Rights Reserved.
NBS Home Page
Contact the NBS webmaster
|